流量：2.34L/H ，壓力：10.5Bar，美國帕斯菲達pulsafeeder機械隔膜計量泵X215加藥泵
200、250系列機械隔膜計量泵流量：2.34L/H ，壓力：10.5Bar，美國帕斯菲達pulsafeeder機械隔膜計量泵X215加藥泵
詳細介紹
*為特殊使用場所而設計之高壓計量泵 *高效率風冷式馬達，油浸式齒輪箱 *金屬增強隔膜，短距離動作沖程，壽命長 *計量**，輸出量可隨意調(diào)整 *高扭力齒輪組，確保高壓力時順利啟動運轉(zhuǎn)
流量：2.34L/H ，壓力：10.5Bar，美國帕斯菲達pulsafeeder機械隔膜計量泵X215加藥泵
Sometimes the output adjusting know can move on its shaft and cause a false output indication. This can happen if the knob set-screw slips or it the unit is disassembled for any reason. The unit can be reset to " O" follows:
1. Remove the dial stop.
2. With the pump running, loosen the locking lever and turn the adjusting knob counter-clockwise until it is "loose" to touch.
3. SLOWLY turn the knob clockwise, using very light finger pressure. It wilf soon start to advance in pulses as the internal cam comes in and out of contact.
4. When light finger pressure will no longer allow movement of the knob between cam contacts, grasp the knob securely and tighten the locking lever fturning clockwise) making sure that the knob does not move. To check for zero point, turn on pump.
There should be no liquid coming out of discharge fitting.
5. Replace dial stop.
6. If the pointer is not at "0", loosen the set-screw on the knob(use a ,078in.-Hex key), and turn pointer to u0", then re-tighten the setscrew while holding the knob in place.
7. A setting of "0" will now give zero output. One full revolution of the knob counter-clockwise will give maximum output. The knob should never be turned more than one full revolution.
